OZONE GENERATOR FOR SPASINSTALLATION & OPERATIONS MANUALFor Models: Platinum MANUFACTURED BYSan Luis Obispo, CA 934014-0025 Rev. B.- 071105

8INSTALLATION FOR LOCATION “C”:Turn off the electrical power and drain the spa at least 12 inches below the air venturi line which provides the best s

Turn off the electrical power and completely drain the spa. The DEL RIGID INJECTOR MANIFOLD must be installed in the spa’s return line after all other

10See ELECTRICAL CONNECTION to complete installation. When the nal electrical connections are completed, rell the spa to its normal operatin

11FAILED DEL SUCTION TESTVery little or no suction may be caused by the list of possible problems below. Review the list then test for suction again.

12The spa’s mechanical system will run exactly as before. Note: If the pump is above the water level of the spa and there is not a apper valve in the

13TROUBLE SHOOTINGSYMPTOM: Cloudy water condition even though the unit appears to be operating properly.PROBABLE CAUSE CORRECTIVE AC

NOTES:14

15NOTES:

 Copyright DEL Ozone 200516NOTES:

DEL Ozone WARRANTY REGISTRATION CARD Product Serial Date:Fill out completely and return to DEL Ozone within ten (10) days of purchase.Customer Info:N

DEL Ozone · ONE YEAR LIMITED WARRANTYThe limited warranty set forth below applies to products manufactured by DEL Ozone, 3428 Bullock Lane, San Luis O

DO NOT FORGET TO CUT OUT AND MAIL THIS CARD FOR INSTANT WARRANTY COVERAGE!DEL OzoneATTN: Warranty Dept.3428 Bullock LaneSan Luis Obispo, CA 93401-9787

IMPORTANT SAFETY INSTRUCTIONSProper installation and safe use of your DEL spa ozonator is your responsibil-ity. Read and follow this Owner’s Manual ca

TABLE OF CONTENTSImportant Safety Instructions... 1Table of Contents ...

HOW THE DEL SPA OZONATOR WORKSThe Spa Eclipse Platinum ozonator that you have just purchased is a high-output ozonator capable of sanitizing spas up t

4INSTALLATIONMOUNTINGNote: For ozonators equipped with a standard “three-prong” plug (NEMA 5-15P), the ozonator must be mounted above the water line,

5OZONE SUPPLY TUBING CONNECTION LOCATIONS:OZONE-READY SPASIf your spa is factory equipped with an ozone injection point, follow the manu-facturer’s in

6INSTALLATION FOR LOCATIONS “A” & “B”:Turn off the electrical power and drain the spa at least 12 inches below the selected “A” (Figure 2) or “B”

7PLASTIC HOSE CONNECTOR INSTALLATION:A plastic hose connector installed onto the air venturi line may be used when the spa is not “ozone ready”. If t